Multitech Zpx Multimodem MT5634ZPX-PCI-V92 Guide de l'utilisateur télécharger pdf (Page 11)

2 Installation

MultiModemZPX User Guide

Installing the Modem Driver in Windows NT 4.0

Before you begin a Windows NT installation, make sure Windows NT Service Pack 3 or newer is installed

on the computer. Also, to add and remove devices you must be logged on with Administrator

privileges.

1. After installing the MultiModemZPX modem into your computer, turn the computer on and allow

Windows NT to start.

2. Insert the MultiModemZPX system CD into your computer’s CD-ROM drive.

3. When the MT5634ZPX-PCI Autorun menu appears, choose Windows NT Setup.

4. The Multi-Tech Systems NT4 PCI Modem Setup dialog box

5. Now click Install. The MT5634ZPX-PCI-V92 driver is installed on the selected COM port.

6. When a message asking you to restart the computer appears, remove the CD from the CD-ROM

drive, and then click OK to restart the computer.

Remote Access Setup

Before you can use your modem, Dial-Up Networking must be installed, and the new modem must be

selected as the Remote Access Service device.

Verifying the Windows NT Configuration

To verify your modem configuration in Windows NT:

1. Click Start | Settings | Control Panel. Double-click Modems.

2. The Modem Properties dialog box appears, showing the COM port associated with the modem.

3. Click Properties. View the General tab to display information about modem speed. Click the

Connection tab to see information about connection and call preferences.

You can also view configuration information under NT’s Remote Access Services, by clicking

Start | Settings | Control Panel. Double-click the Network tab. Click the Services tab, Highlight

Remote Access Services and then click Properties. The list of modems and associated COM ports

appears.

11. C

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Pas de commentaire

Multitech Zpx Multimodem MT5634ZPX-PCI-V92 Guide de l'utilisateur Page 11