Multitech Zpx Multimodem MT5634ZPX-PCI-V92 Guide de l'utilisateur télécharger pdf (Page 36)

E Installing Under SCO OpenServer

MultiModemZPX User Guide

AppendixAppendix

Appendix

E - Inst E - Inst

E - Inst

alal

ling Undling Und

ling Und

erer

SC SC

O OpenSerO OpenSer

O OpenSer

erer

Introduction

This appendix explains how to install a modem on a computer operating under the SCO OpenServer

5.0.x operating system. Briefly, in SCO OpenServer , you do not need drivers for most modems.

Programs in SCO OpenServer commonly call upon the port, rather than the modem.

Installation

Install the MultiModemZPX in the computer as described in Chapter 2.

Setup

1. Turn on the computer and allow the computer to boot to the command prompt.

2. Log in as root.

3. Determine the port address and IRQ for the modem by typing: hw -r pci

To output the port address and IRQ information to a file, type: hw -r pci>pci.txt

Caution: If you choose to output the information to a file, make sure the output file name

includes the .txt extension. While logged on as “root”, the possibility exists that the system file

“pci” will be overwritten. By default, UNIX does not ask if you want to overwrite a file.

4. Look at the ClassCode: 0x078000 (other communications device) section of the output. The

MultiModemZPX is identified as SubSystemID: 0x0480.

5. Use the first I/O address listed as the port address. In the output, look for:

BaseAddr [x]: I/O NxNNNN

where x is the first I/O base address (not memory) and NxNNN is the I/O address.

6. Use Serial Manager (or mkdev serial) to add a serial port. Choose IBM Com X for the new

port, where X is the number of the new port. Use the first I/O address listed in the output file

created in step 3 (BaseAddr [x]:) as the port address.

7. Use the IRQ listed in the InterruptLine of the output file created in step 3.

8. Once the serial port has been added, the system will require the kernal to be relinked. After

the relinking is complete, restart the system to activate the changes.

9. Log back on as root.

10.At this point, you may configure the modem as needed on the new port and add required

entries to Devices.

11.Once you’ve completed your hardware installation and system setup, you must configure

your modem for country-specific operation. Refer to Chapter 2 for information on using AT

commands to configure the modem for use in your country.

Note: If you are using the modem to dial out, a dialer may be needed.

1 2 ... 31 32 33 34 35 36 37

Commentaires sur ces manuels

Pas de commentaire

Multitech Zpx Multimodem MT5634ZPX-PCI-V92 Guide de l'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Modems Multitech Zpx Multimodem MT5634ZPX-PCI-V92