Multitech MTCBA-G-F2 Guide de l'utilisateur télécharger pdf (Page 36)

Getting Started

36

Verifying network registration

In this procedure, you will verify that the Wireless

MultiModem has been registered on the wireless

network. To do so, you will use the common

communications program

Hyperterminal.

1. Using the

Hyperterminal program at the

computer to which the Wireless MultiModem

is connected, type the AT command

AT+CREG?. A value for the modem’s network

registration status will be returned.

2. Verify the result with the following chart:

Network Registration Verification

Value Network Registration Status

0, 1 Yes

0, 5 Yes

(registered roaming)

Note: If the modem is not registered, perform the

procedure for

Verifying signal strength on

page 38 to determine the strength of the

received signal.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 60 61

Commentaires sur ces manuels

Pas de commentaire