AcquiSuiteUSB Modem AddendumApplies to: A8812 AcquiSuite, A8810 AcquiSuite EMB, A7810 AcquiLiteDate Nov 30, 2011Page 1 USB Modem Addendum
The Radicom-V92HU-E2• No LEDs whatsoever.• No speaker.Page 10 USB Modem Addendum
The TrendNET TFM-561U• A “clone” of the Radicom-V92HU-E2, but with LEDs.• Link LED – on when the modem has “connected” to the remote modem.• Data LED
Cellular ModemsIn addition to the onboard cellular-modem options of the A8812 model, the AcquiSuite/AcquiLite DAS support the following USB cellular m
Here is a close-up of the Mulitech's front-panel showing the LEDs and slot for GSM SIM card:Page 13 USB Modem Addendum
New Features of the AcquiSuite/AcquiLite's LCDTogether with support for USB modems, the LCD console of the AcquiSuite/AcquiLite DAS has several n
InstallationStep 1: Plug it inTo begin “installing” a USB modem, plug it into the AcquiSuite or AcquiLite DAS's USB port.No modem drivers are nee
Note: If dial-in or dial-out is enabled but the DAS does not find a modem of the expected type or the modem fails to initialize, the DAS will report
2. You are using a USB hub, and possibly other USB devices, and the combination of the hub, other devices and the USB modem exceeds the total power th
Step 3: Enable & Configure Dial-OutIf you wish the DAS to automatically dial-out to upload meter data, you must enable and configure this via the
Test Dial-Out by Running a “Connection Test”Once you've enabled and configured dial-out, test these settings by running a Connection Test, via th
Copyright InformationCopyright © 2001 - 2011 by ObviusObvius and AcquiSuite are trademarks of Obvius Holdings LLcOther brand and product names are t
LCD Messages While Dialing-OutThe AcquiSuite/AcquiLite DAS will display the following messages on its LCD while dialing out. These can be used to dia
Modem Connecting / Waited N so farIf the call takes longer than 15 seconds to connect, the DAS will remind you that it is still connecting with this m
Connect failed: NO LINE or NO CARRIERThe DAS now begins the process of uploading data for each of the enabled upload channels. Example messages are sh
The DAS will then continue on with channels 2 through 4 (if they are enabled):Page 23 USB Modem Addendum
Dialout Success: / Hanging up, DoneIf the entire upload cycle completes, the DAS will display the following on its LCD. If the call was dropped for s
Step 4: Enable & Configure Dial-In“Dial-in” allows the DAS to be remotely administered and allows data to be “pulled” from the DAS using Obvius&ap
The Dial-In WatchdogIf dial-in is enabled, the DAS will also enable a “dial-in watchdog timer”. The “dial-in watchdog timer” will cause the DAS to gr
Modem Connected / Receiving PPPThe DAS has answered the call, connected to the remote modem, and is negotiating a PPP connectionDial-in Failed: Bad PP
Page 28 USB Modem Addendum
Detailed Explanation of the “Modem Setup” OptionsThe “Modem Setup” Web PageThis configuration option will allow you to configure specific features in
Table of ContentsIntroduction...
The “Modem Setup” Page -- Options for GSM Cellular ModemsGSM band: Lets you select the GSM frequency band. GSM signal strength: Displays the most rece
IntroductionBeginning with AcquiSuite firmware version v02.11.1106b, the AcquiSuite Data Acquisition Servers (DAS) support the following optional USB
Planning the Installation of a “POTS” ModemTo install a USB “POTS” modem, you will typically need the following:1. [__] The modem itself;2. [__] The m
Planning the Installation of the Multitech GPRS/GSM Cellular ModemTo install the Multitech GPRS/GSM cellular modem, you will typically need the follow
Comparing “POTS” ModemsThe 3 new POTS modems are pictured on the next page, with close-ups on the following pages.Compared to the built-in modems of t
Page 8 USB Modem AddendumIllustration 1: Comparing "POTS" modems: USRobotics, TrendNET, Radicom
The USRobotics USR5637• Power LED – on when modem is receiving power from the USB port.• Data LED – blinks when modem is connected and transferring da
Commentaires sur ces manuels