Multitech MTA128ST-USB Guide de l'utilisateur télécharger pdf (Page 25)

Chapter 3 - Configuration

Multi-Tech Systems, Inc. MTA128ST-USB External ISDN Terminal Adapter PN S000340 25

5. When you finish configuring the MTA128ST-USB, exit the configuration utility.

AT Commands

You can configure the MTA128ST-USB using AT commands, just as you would configure an

analog modem. Use this method if you prefer to work with AT commands or if you have a special

requirement not addressed by the configuration utility.

Using AT Commands to Configure the MTA128ST-USB

1. Connect the MTA128ST-USB to the USB port on your PC.

2. Turn on the MTA128ST-USB. Once the drivers are installed, Windows will automatically

detect the presence of the MTA128ST-USB and activate the associated COM port.

3. Open a data communication session using HyperTerminal or your favorite

communications program. Select the COM port where the MTA128ST-USB is

connected.

4. Enter the desired AT commands in the terminal window of the data communications

program.

5. When you finish making changes, use the &W command to save and automatically load

the new configuration when the MTA128ST-USB is turned on.

6. Quit the data communications program.

For more information on AT commands, refer to Chapter 4 in the on-line User Guide.

1 2 ... 20 21 22 23 24 25

Pas de commentaire

Multitech MTA128ST-USB Guide de l'utilisateur Page 25