Multitech MT1432BA Manuel d'utilisateur Page 162
- Page / 166
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
162
MultiModemBA User Guide
Canadian Limitations Notice
Notice: The ringer equivalence number (REN) assigned to each terminal device provides an
indication of the maximum number of terminals allowed to be connected to a telephone interface. The
termination of a interface may consist of any combination of devices subject only to the requirement
that the sum of the ringer equivalence numbers of all the devices does not exceed 5.
Notice: The Industry Canada label identifies certificated equipment. This certification means that the
equipment meets certain telecommunications network protective, operational and safety
requirements. The Industry Canada does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
Class A Statement
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel
brouilleur du Canada.
- BA-Series 1
- Intelligent Data/Fax Modem 1
- User Guide 1
- Contents 3
- Chapter 5 - Command Mode 4
- Chapter 6 - S-Registers 4
- Chapter 8 - Modem Testing 5
- 1.1 Introduction 8
- 1.2 How To Use This Manual 8
- 1.3 Modem Features 10
- 1.3.1 2834 Series Features 10
- 1.3.2 1432 Series Features 10
- 1.3.3 932 Series Features 10
- 1.4 Fax Features 11
- 1.5 Technical Specifications 12
- 1.6 Power 16
- 1.7 Modem LED Indicators 16
- 1.8 Controls on PC Board 17
- MADE IN U.S.A 20
- 2.2 Installation 21
- 2.2.1 Safety Warnings 21
- 2.2.2 Installation Procedure 21
- EIA RS232C 22
- 3.1 Introduction 28
- 3.2 Serial Port Limitations 28
- 3.3 Configuring Your Software 29
- 3.4 PC Initialization Strings 30
- 3.4.2 Other Parameters 30
- 3.5 Macintosh Initialization 31
- 3.6.2 Terminal Emulation 31
- 3.6.3 File Transfer Protocols 32
- 3.8 Modem Basics 33
- 3.8.1 Simple Operations 33
- 4.1 Introduction 36
- 4.2 Dialing/On-Line/Answering 36
- 4.3 Manual Call Origination 37
- 4.4 Automatic Answering 37
- 4.5 Manual Answering 38
- 4.6 Handshaking Details 38
- 4.7 Call Termination 39
- 5.1 Introduction 42
- 5.1.1 AT Command Editing 42
- 5.1.2 Functional Modes 43
- 5.2 Summary of AT Commands 44
- 5.3 Result Codes 47
- 5.4 Dialing Commands 49
- 5.4.1 Dialing Action Commands 49
- 5.4.2 Dial Modifier Commands 50
- Quiet Answer @ 52
- Storing Phone Numbers D...N 53
- Number Linking NN 53
- Modem Reset Z 54
- Unix UUCP Spoofing $SP 55
- Bell/V.21 Tone B 58
- Auto Speed Detect #A 60
- Carrier Detect Control &C 61
- CTS Control &R 61
- Data Set Ready Control &S 62
- Normal Mode &E0 63
- Auto-Reliable Mode &E1 63
- Reliable Mode &E2 63
- V.42 Mode Select #L 64
- Auto-Reliable Buffering $A 64
- Retransmit Count $R 65
- 5.4.9 Flow Control Commands 66
- Xon/Xoff Pass-Through &E7 67
- Send Xon/Xoff Characters #X 67
- Maximum Block Size &BS 68
- Parity Selection #P 68
- Through and Pacing Commands 69
- Speed Conversion $BA 70
- Modem Baud Rate $MB 70
- Serial Port Baud Rate $SB 72
- Help Screens $H 73
- Inquiry for Product Code I 73
- Listing S-Register Values L6 73
- Off Hook H 74
- BREAK AT<CR> 74
- Force Answer Mode A 75
- 6.1 Introduction 78
- Remote Configuration 87
- 7.1 Introduction 88
- Configuration 89
- Change LOGIN Password #I 93
- Change SETUP Password #S 93
- Callback Time Delay (S15) 95
- Callback Attempts (S16) 95
- Local Inactivity Timer (S29) 95
- 8.1 Introduction 98
- Digital Analog 99
- Digital Analog DigitalAnalog 100
- 8.5 Back-to-Back Test 102
- 8.6 Synchronous Mode Testing 103
- MultiModemBA User Guide 106
- 9.1 Introduction 108
- Switch #15 114
- Switch #16 114
- (Reserved for Future Use) 114
- 9.3 Speaker Volume Control 115
- DIP Switches #13-14 116
- DIP Switches #15-16 116
- 10.1 Introduction 118
- 10.2 Limited Warranty 118
- 10.3 Tech Support 119
- 10.4 Service 119
- 10.5 The Multi-Tech BBS 120
- Appendixes 123
- Appendix A - Troubleshooting 124
- I Am Losing Data 128
- Dial Pulses 130
- Tone Dial Frequencies 130
- Appendix D - Command Summary 131
- Password Command Summary 139
- V.25bis Commands 139
- Asynchronous Mode 140
- Synchronous Mode 141
- Delayed and Forbidden Numbers 147
- V.25bis Operation 147
- V.25bis Mode AT Commands 149
- V.25bis AT Commands 150
- DTR Dialing ($D) Command 151
- 25-PIN DTE 154
- Connector 154
- 25-PIN DCE 154
- Test Voltage - Pin 9, XV 158
- Canadian Limitations Notice 162
- Class A Statement 162
Produits connexes et manuels pour Modems Multitech MT1432BA
(66 pages)Samsung DM-V599 manuály
Uživatelské manuály a uživatelské příručky pro Základní desky Samsung DM-V599.
Poskytujeme 1 manuály pdf Samsung DM-V599 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Samsung DM-V599 Uživatelský manuál (90 strany)
Značka: Samsung | Kategorie: Motherboards | Velikost: 9.66 MB |
Tabulka s obsahem
5 장 . 부록
3
업그레이드 관련
14
보관 및 이동 관련
15
사용시 올바른 자세
20
사용시간 (휴식시간)
22
각 부분의 명칭
24
키보드와 마우스 연결
26
전원 케이블 연결
29
컴퓨터 켜기 / 끄기
30
소리 조절 키
33
(선택 사양)
34
클릭(누름) 기능
36
드래그(끌기) 기능
36
CD 넣고 빼기
37
트레이에 걸쳐 놓으세요
38
멀티 카드 슬롯
39
메모리카드 사용하기
41
메모리카드 제거하기
42
메모리카드 포맷하기
42
듀얼 뷰를 해제하려면
51
볼륨 조절 프로그램에서
54
유선 네트워크 56
55
BIOS 셋업 59
55
부팅 순위 변경 66
55
네트워크 연결하기
56
BIOS 셋업 화면
60
셋업에서 사용하는 키
61
부팅 비밀번호 설정
62
하드 디스크 비밀번호
63
설정하기 (선택 사양)
63
비밀번호 해제하기
64
부팅 순위 변경
66
CPU 속도 조절 기능
67
CPU 가속화 기능
68
컴퓨터 덮개 열기
70
컴퓨터 내부 구성
72
메인보드의 구성
73
[HD6770]
74
[GTX550TI]
74
CPU 고정바
83
CMOS 배터리 교체
84
제품 규격 86
85
BP399/MV599
86
전자파 적합 등록 안내
88
(Class B)
88
친환경상품 소비자정보
88
폐 전자제품 처리 안내
89
1588-3366
90
Další produkty a příručky pro Základní desky Samsung
| Modely | Typ Dokumentu |
|---|---|
| DM700A3C | Uživatelský manuál Samsung DM700A3C 사용자 설명서, 117 stránky |
| DM-X15 | Uživatelský manuál Samsung DM-X15 사용자 설명서 [da] [sv] , 164 stránky |
| DM500S3A | Uživatelský manuál Samsung DM500S3A 사용자 설명서, 126 stránky |
| MZ30 | Uživatelský manuál Samsung MZ30 사용자 설명서 [sk] , 113 stránky |
| SPH-P9200 | Uživatelský manuál Samsung SPH-P9200 사용자 설명서, 108 stránky |
| MP30 | Uživatelský manuál Samsung MP30 사용자 설명서, 120 stránky |
| NP300V4ZH |
Uživatelský manuál
Samsung NP300V4ZI Používateľská príručka,
80 stránky
|
| NT910S3GI | Uživatelský manuál Samsung NP905S3GI 사용자 설명서, 129 stránky |
| DM-Z66 | Uživatelský manuál Samsung DM-Z66 사용자 설명서, 110 stránky |
| DM300S1A | Uživatelský manuál Samsung DM301S1A 사용자 설명서, 112 stránky |
| SQ25 |
Uživatelský manuál
Samsung SQ25 User manual [da] ,
134 stránky
|
| DM-Z60 | Uživatelský manuál Samsung DM-Z60 사용자 설명서, 180 stránky |
| SQ20 |
Uživatelský manuál
Samsung SQ20 User manual,
131 stránky
|
| NT500R5QJ | Uživatelský manuál Samsung NT500R5QJ User Manual (Windows 7), 92 stránky |
| DM500T4Z | Uživatelský manuál Samsung DM500T4Z 사용자 설명서 [en] , 80 stránky |
| DB400T2Z | Uživatelský manuál Samsung DB400T2Z 사용자 설명서, 85 stránky |
| ZDZ25 | Uživatelský manuál Samsung ZDZ25 사용자 설명서, 86 stránky |
© 2020, manymanuals.fr. Tous droits réservés | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels