Multitech ISIHP-4U Guide de l'utilisateur télécharger pdf (Page 97)

Chapter 5 - AT Commands

DN/MSN 1 will be routed to the first modem.

Usage: *!N2=n

Function: Modem DN/MSN 2

Values: n=25-character string

Default: null string

Description: Modem DN/MSN 2 can be set to the same value as Modem DN/MSN 1 and it can

also be set to the same value as Data DN/MSN 1 and/or 2. A call accepted by Modem DN/MSN

2 will be routed to the second modem.

Usage: *!DNn

Function: Disable Modem DN/MSN n

Values: n=1 (disable Modem DN/MSN 1),

n=2 (disable Modem DN/MSN 2)

Default: All ports are enabled by default

Description: *!DNn disables a Modem DN/MSN which will effectively disable the associated

modem port from receiving any modem calls. However, the port will still be able to originate

modem calls. This is useful for applications where a specific port is for dial-out only.

Usage: *!ENn

Function: Enable Modem DN/MSN n

Values: n=1 (enable Modem DN/MSN 1),

n=2 (enable Modem DN/MSN 2)

Default: All ports are enabled by default

Description: *!ENn enables a Modem DN/MSN which will put it back in service for accepting

and originating modem calls.

!ENn Enable Data DN/MSN n

Unit: Decimal ASCII code

Values: n=1 (enable Data DN/MSN 1),

n=2 (enable Data DN/MSN 2)

Default: All ports are enabled

!ENn enables a Data DN/MSN which will put it back in service for accepting and originating

data calls. If no port number is given then the assumed port number is that of the port from

which the command was received. AT!L<CR> may be used to review which ports are enabled

(any port that does not display PORT DISABLED). The @CONFIG configuration menu can

also be used to enable or review the disabled ports.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 129 130

Pas de commentaire

Multitech ISIHP-4U Guide de l'utilisateur Page 97