Multitech CF220 Guide de l'utilisateur

CallFinder® DID DID-to-Analog Adapter Model CF220-DID Cabling Guide

CallFinder Cabling Guide If it is a 192.168.2.x subnet, it may clash with the CallFinder because the CallFinder’s default IP address is 192.168.2.1.

CallFinder Cabling Guide MultiTech Systems, Inc. 11 Identify CallFinder’s Extension Ports (FXS/FXO) for Later Hookup Caution: You must wait until af

Patents This device is covered by one or more of the following patents: 6,031,867; 6,012,113; 6,009,082; 5,905,794; 5,864,560; 5,815,567; 5,815

2 MultiTech Systems, Inc.CallFinder DID Cabling Guide Model CF220-DID 82100292L

CallFinder Cabling Guide Introduction This guide describes the hardware setup of the CF220-DID CallFinder unit, and some preliminary considerations fo

CallFinder Cabling Guide 4 MultiTech Systems, Inc. We Supply • A CallFinder (CF22

CallFinder Cabling Guide MultiTech Systems, Inc. 5 CallFinder Operation The CallFinder brings analog DID services to a key telephone system or PBX th

CallFinder Cabling Guide Quick Hookup for CF220-DID CHANNEL 2CHANNEL 1RESET10/100FXS/FXO DIDFXS/FXO DIDCabling to telco DID lines.Connector

CallFinder Cabling Guide Cabling Instructions Summary: Place the CallFinder in a convenient location, and then connect it to earth ground, to your AC

CallFinder Cabling Guide Connect CallFinder to Power Insert the 9 Vdc power connector into the CallFinder’s power receptacle and fasten it with the l

CallFinder Cabling Guide Verify powering. After power is applied, the PWR LED comes on immediately but there is a 4-second delay before the Status LE