Multitech MT5656SMI Guide de l'utilisateur télécharger pdf (Page 86)

Part 6 – Commands for GPS-Enabled Devices Chapter 16 – Commands for GPS-Enabled Devices

Universal IP AT Commands Reference Guide (Document S000457H) 86

Chapter 16 – Commands for GPS-Enable

Products

#GPSSERV – Set GPS Host Server Address

Definition: This command sets the server IP address or name to which the GPS data will be sent.

Syntax: Set Value: AT#GPSSERV="<value>"

View Value: AT#GPSSERV? or AT#VGPS or AT#VALL

Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or

Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.

Responses: OK

Otherwise ERROR

#GPSPORT – Set GPS Host Port

Definition: This command sets the GPS host port (TCP, UDP).

Syntax: Set Value: AT#GPSPORT=<port number>

View Value: AT#GPSPORT? or AT#VGPS or AT#VALL

Values: 1 to 65535

Default: 0

Responses: OK

Otherwise ERROR

#GPSPROTO – Set GPS Host Protocol

Definition: This command sets the server protocol that the GPS will use (TCP, UDP).

Syntax: Set Value: AT#GPSPROTO=<value>

View Value: AT#GPSPROTO? or AT#VGPS or AT#VALL

Values: 0 UDP

1 TCP

Default: 0

Responses: OK

Otherwise ERROR

#GPSPREFIX – Set GPS Message Prefix

Definition: This command is used to set a unique identification for each device or vehicle.

Syntax: Set Value: AT#GPSPREFIX="<value>"

View Value: AT#GPSPREFIX? or AT#VGPS or AT#VALL

Values: Up to 4 characters in an alphanumeric string

Note: The prefix is appended to the NMEA message before transit

Default: " "

Responses: OK

Otherwise ERROR

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 106 107

Pas de commentaire

Multitech MT5656SMI Guide de l'utilisateur Page 86