Multitech MVP 800 Guide de l'utilisateur télécharger pdf (Page 38)

MultiVOIP User Guide

If you are connecting the station side of a telephone switch (PBX) to your MultiVOIP, connect

one end of an RJ11 phone cord to the Voice/Fax Channel 1 FXO connector on the back of

the MultiVOIP and the other end to the phone jack.

If you are connecting an E&M trunk from a telephone switch to your MultiVOIP, connect one

end of an RJ45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the

MultiVOIP and the other end to the trunk. Refer to Appendix B for E&M cabling pinout.

If you are connecting to an E&M trunk, you need ensure that the E&M trunk jumper is in the

correct position for the E&M type trunk. The default E&M jumper position is E&M type 2. To

change the E&M jumper position, perform the E&M jumper block positioning procedure.

7 Repeat the above step to connect the remaining telephone equipment to each Voice/Fax

Channel on your MultiVOIP.

8 Turn on power to the MultiVOIP by placing the ON/OFF switch on the back panel to the ON

position. Wait for the BOOT LED on the MultiVOIP to go OFF before proceeding. This may

take a couple of minutes to go OFF.

9 At this time your VOIP network should be fully operational, dial one of the sites in your

network using the dialing directory supplied by your VOIP Administrator.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 87 88

Pas de commentaire

Multitech MVP 800 Guide de l'utilisateur Page 38