Multitech PROXYSERVER MTPSR1-120 Guide de l'utilisateur télécharger pdf (Page 15)

Chapter 2 - Installation

Table 2-1. (cont’d.)

Step Procedure

5. If a cable modem, DSL modem, or your Internet LAN is being used, no cable connection

will be made to the RS232/V.35 connector on the back of the ProxyServer.

If the RS232/V.35 connector on the ProxyServer is going to be connected to a WAN

device (i.e., connecting your secure (private) LAN to an ISP, connect one end of an

RS232 or V.35 interface cable to the RS232/V.35 connector on the back of the

ProxyServer. Connect the other end of this cable to the WAN device.

6. Turn on power to the ProxyServer by placing the ON/OFF switch on the back panel to

the ON position. Wait for the Fail LED on the ProxyServer to go OFF before proceeding.

This may take a couple of minutes to go OFF.

At this time your ProxyServer is completely cabled. Proceed to Chapter 3 to load the Firewall

software.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Pas de commentaire

Multitech PROXYSERVER MTPSR1-120 Guide de l'utilisateur Page 15