Multitech RouteFinder MTASR3 Guide de l'utilisateur télécharger pdf (Page 10)

RouteFinder MTASR3 Quick Start Guide

Changing Shunt Positions

Table 3 provides the procedure for moving the link shunts before

connecting the RouteFinder to an external composite link device

that has a V.35 interface.

Table 3. V.35 Shunt Procedure

Step Procedure

1 Ensure that the external power supply is disconnected

from the RouteFinder.

2 Turn the unit upside down and remove the cabinet

mounting screw. See Figure 5.

Enclosure Mounting

Screw (center, back)

Systems

Figure 5. Cabinet Mounting Screw

3 Turn the unit right side up and tilt the back down slightly

and the base will slide out of the cabinet.

4 Position the unit with the LEDs toward you, as in Figure 6.

5 Pry the shunt out of the default RS232 position for the link

being changed, then install the shunt in the V.35 position

for that link. See Figure 6.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Pas de commentaire

Multitech RouteFinder MTASR3 Guide de l'utilisateur Page 10