Multitech RF560VPN Manuel d'utilisateur télécharger pdf (Page 26)

Multi-Tech Systems, Inc.

RF550VPN/RF560VPN Reference Guide – Setup Examples 26

Testing Your Configuration

You can test your connection between the two RouteFinders using the PING command at a DOS prompt.

At the Site A workstation connected to a LAN port of the RF550VPN/RF560VPN:

At the DOS prompt PING a workstation connected to the LAN port of the RF550VPN/RF560VPN

at Site B.

Example: PING 192.168.10.100 <return>

You should see four successful packet transmit/receive statements. If you do not, try several

more times. You may see several initial failures while the two RouteFinders make a secure

connection.

If this fails, try to PING the WAN port of the RF550VPN/RF560VPN at Site B.

Example: PING 204.26.122.3

You should see four successful packet transmit/receive statements. If you do not, try several

more times. You may see several initial failures while the two RouteFinders make a secure

connection.

If this fails, try to PING the WAN port of the RF550VPN/RF560VPN at Site A.

Example: PING 204.26.122.103

Note: If any of these tests fail then verify that the workstation is connected to the LAN port of the

RF550VPN/RF560VPN. The LAN port LINK LED should be on and the ACT LED should blink on

each time you PING the RF550VPN/RF560VPN. Verify the WAN port at each Site is connected

properly. Also verify that the RF550VPN/RF560VPN is configured properly.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 58 59

Pas de commentaire

Multitech RF560VPN Manuel d'utilisateur Page 26