Multitech MTS2BTA-R Spécifications télécharger pdf (Page 9)

Serial-to-Bluetooth Adapter

5. Place radio into Fast Data Mode.

Sent: +++<cr> // Places radio in Command Mode

Reply: <cr_lf>OK<cr_lf>

Sent: ATMF<cr> // Places radio in Fast Data Mode

Reply: <cr_lf>OK<cr_lf>

6. Send Data.

Note: Sending commands from the slave when the slave

connects in Fast Data Mode (ATSW25/ or issue ATMF):

All valid AT commands sent through the Slave's UART will be

interpreted and responded by the Master as if it were the local

Slave radio. Basically, in this configuration from the Slave end,

you can obtain status and configure the remote Master radio.

This is a unique feature that may be useful in some

applications, but it can be confusing if you think you are talking

to the Slave.

To Get Out of Data Mode and Check Status

1. Delay at least 50 milliseconds; this could be less or more.

2. Perform a Set Command Mode.

Sent: +++<cr>

Reply: <cr_lf>OK<cr_lf>

3. Delay at least 50 milliseconds.

4. Check Status, perform a Disconnect …

Sent: AT<cr>

Reply: <cr_lf>OK<cr_lf>

Note about being connected in Fast Data Mode

If connected in Fast Data Mode, it is necessary to reset the

Master or Slave to break the connection.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Multitech MTS2BTA-R Spécifications Page 9