Multitech E Spécifications télécharger pdf (Page 28)

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE

The device responds with OK.

To close the data connection:

■ Enter: AT#SGACT=1,0

The device responds with OK.

Configuring Device as UDP Listener to Accept UDP Client Connections

To configure the device as a UDP client:

1. Check signal strength.

Enter:

AT+CSQ

2. If using a SIM card, configure the APN.

Enter:

AT+CGDCONT=1,IP,"XXX.APN.com" where XXX.APN.com is the APN your cellular provider assigned to

your SIM card.

3. Verify device is registered on the cellular network.

Enter:

AT+CREG?

4. Configure socket parameters

Enter:

AT#SCFG=1,1,300,240,600,50

5. Activate context one

Enter:

AT#SGACT=1,1

6. Set firewall rule to accept connections:

AT#FRWL=1,"###.##.###.#","###.##.###.#" where ###.##.###.# represents the IP range. For example:

AT#FRWL=1,"204.26.122.1","204.26.122.255"

7. Set connection ID 1 for UDP listening mode on port 7000.

Enter:

AT#SLUDP=1,1,7000

The device responds with and unsolicited indication that a host is trying to connect to connection ID 1 on

port 7000.

SRING: 1

8. Accept incoming connection ID 1

Enter:

AT#SA=1

The device indicates a client successfully established a listener connection.

CONNECT

You can send and receive data.

Exit Data Mode and Close Connection

To exit data mode and close the socket:

28 QuickCarrier™ USB-E MT100UCC-C2 Developer Guide

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Multitech E Spécifications Page 28