Multitech MULTIVOIP MVP-130 Guide de l'utilisateur télécharger pdf (Page 23)

Chapter 2 - Configuration

Multi-Tech Systems, Inc. Avaya Communication Manager Guide 23

7f. Configure the “Survivable GK Node Name” field with the node name previously given to the

MultiVOIP in the “Node-Names IP” form.

Avaya IP phones running firmware version 2.0 or higher require CM 2.0.1 or higher to work in

survivable mode with the MultiVOIP. When these phones register with the CM, they replace the

list of gatekeepers acquired from the DHCP server (including the MultiVOIP) with a new list of

gatekeepers acquired from CM. This differs from 1.x IP phone firmware where the gatekeeper list

sent to the IP phone from CM was appended to the list of gatekeepers acquired from the DHCP

server. When using CM 2.0.1 or higher, configure the “Survivable GK Node Name” field in the

station form for the IP phone. By doing this, the MultiVOIP will be included in the list of

gatekeepers sent to the IP phone by CM.

Note: IP phone models 4610SW and 4620SW only support 2.0 or higher firmware, therefore these

phones cannot be used with the MultiVOIP unless you are using CM 2.0.1 or higher.

7g. The completed Endpoints screen is shown below:

7h. Click on Save Setup|Save GK Parameters to save the gatekeeper settings.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 78 79

Pas de commentaire

Multitech MULTIVOIP MVP-130 Guide de l'utilisateur Page 23