Multitech MultiVOIP 100 MVP120 Guide de l'utilisateur télécharger pdf (Page 10)

MultiVOIP Quick Start Guide

2. Connect the MVP120 to a PC using the RJ-45 to DB9

(female) cable provided with your unit. Plug the RJ-45 end

of the cable into the Command port of the MVP120 and

connect the other end to the PC’s serial port (Figure 3).

3. Connect a network cable to the Ethernet 10Base-T

connector on the back of the MVP120. Connect the other

end of the cable to your network.

4. Connect an RJ-11 cable to the Voice/Fax Channel

connector on the back of the MVP120 and the other end to

the PSTN or FXO PBX port.

5. Turn on power to the MVP120 by setting the power switch

on the right side to the On position. Wait for the Boot LED

on the MVP120 to go off before proceeding. This may take

a couple of minutes.

Note: Since the MVP120 doesn’t have a power LED, no

LEDs will be lit if there is no activity after boot up, unless

the ethernet port is connected to the network.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Pas de commentaire

Multitech MultiVOIP 100 MVP120 Guide de l'utilisateur Page 10