Multitech MultiVOIP 400 MVP400 Guide de l'utilisateur télécharger pdf (Page 35)

Software Installation

8. To change the voice coder, select the channel from the

Select Channel list, then select the new voice coder entry

from the Voice Coder list.

If you changed the voice coder, ensure that the same

voice coder is used on the voice/fax channel you are

calling. Otherwise, you will always get a busy signal.

9. If you selected the FXO interface and are using touchtone

dialing, you can set up the DTMF gain (or output level in

decibels - dB) for the higher and lower frequency groups

of the DTMF tone pair. Make your selections from the lists

in the DTMF Gain group. In the Duration box, enter the

DTMF tone duration in milliseconds. 100 is entered by

default.

Note: Only change the DTMF gain under the direction of

Multi-Tech Technical Support.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Pas de commentaire

Multitech MultiVOIP 400 MVP400 Guide de l'utilisateur Page 35