Multitech MVPFXS-24 Guide de l'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 165
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
Phone/IP Starter Config. MultiVOIP FX Quick Start Guide
22
7. Reboot the MultiVOIP by turning off its power and turning it back on again.
The ARMBoot prompt will appear on the HyperTerminal screen.
When this screen appears, you must quickly press any key to stop the regular boot-up process (the manual
boot process).
8. Type setenv ipaddr a.b.c.d where a, b, c, & d are the octet values for the desired IP address of the voip.
Press Enter.
Note: When using the setenv command, be careful in your spelling. If you mis-spell ipaddr as “ipadde” for
example, the ARMBoot program will create a new and useless variable entitled ipadde and will not change
the value of the ipaddr variable.
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 164 165

Commentaires sur ces manuels

Pas de commentaire