Multitech RouteFinder RF850 Guide de l'utilisateur télécharger pdf (Page 90)

Chapter 6 – RouteFinder Software

Multi-Tech Systems, Inc. RouteFinder RF850/860 User Guide (PN S000400E) 90

Network Setup > PPPoE

PPPoE (Point-to-Point Protocol over Ethernet) is a specification for connecting multiple computer users on an

Ethernet local area network to a remote site through DSL or cable modems or similar devices. PPPoE can be

used to have an office or building-full of users share a common Digital Subscriber Line (DSL), cable modem, or

wireless connection to the internet. PPPoE combines the Point-to-Point (PPP), commonly used in dialup

connections, with the Ethernet protocol which support multiple users in a local area network.

Important: If DHCP client is enabled, the PPPoE cannot be used. The internet connection can be either PPPoE

or DHCP client at any given time.

PPPoE when Load Balancing is Disabled

PPPoE when Load Balancing is Enabled

PPPoE on eth1 (WAN)

Enable PPPoE on eth1 or Enable PPPoE on WANLINK1 (eth1)

To enable PPPoE on eth1, check the corresponding box. This will enable the interface connected to

the ADSL modem (this will be the interface to the internet).

User Name

This field defines the ADSL User Name given by the ISP.

Password

The user’s password must be entered in this field.

MTU

The value entered here will cause PPPoE to set the TCP maximum segment size. The default value

is 1412. The allowed range of values is 536 to 1452.

DNS Address from Peer

Check this box if you want to obtain DNS server addresses from the peer (i.e., the ISP).

Save

Click Save to activate these settings.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 189 190

Pas de commentaire

Multitech RouteFinder RF850 Guide de l'utilisateur Page 90