Multitech RF310E Guide de l'utilisateur télécharger pdf (Page 102)

RASFinder RF300E/RF310E User Guide

RF300E/RF310E102

LAN-Based

The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP

protocol software must be installed and functional before the configuration program can be used.

1. You must assign an Internet (IP) address for the PC and for each node that will be managed by

the configuration program. Refer to the protocol software documentation for instructions on how

to set the IP addresses.

Once you have completed this step, you should be able to use the protocol Ping command for

the PC host name. You should also test the network interface configuration by Pinging another

TCP/IP device that is connected to the network.

2. Install the RASFinder software on the local PC. When installed, click Start | Programs |

RASFinder | Configuration Port Setup, or double-click the Configuration Port icon in the

RASFinder program group.

3. The Port Setup dialog box is displayed.

Verify that the Communication Type field is set to IP.

In the Router IP Address field, enter the IP Address of the remote RASFinder.

4. Click OK when you are satisfied with your selections.

5. Run the RASFinder Configuration program. Click Start | Programs | RASFinder | RASFinder

Configuration, or double-click the RASFinder Configuration icon in the RASFinder program

group.

The following screen is displayed.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 198 199

Pas de commentaire

Multitech RF310E Guide de l'utilisateur Page 102