Multitech RF310E Guide de l'utilisateur télécharger pdf (Page 83)

Chapter 5 - Client Setup

RF300E/RF310E 83

Configuring in Windows NT

Perform the following steps to set up your Windows NT workstation PC:

Note: All of the hardware and screen samples in this section are intended as examples only. Please

select options appropriate to your network.

1. Click Start | Settings | Control Panel.

Double click the Network icon.

2. The Network dialog box is displayed. Click the Protocols tab.

A list of protocols currently present on your PC is displayed. Check the installed protocols. If you

find TCP/IP Protocol listed, proceed to step 4. If TCP/IP is not listed, you must install it prior to

proceeding. Refer to Installing TCP/IP (WinNT) at the end of this section.

Click the Bindings tab.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 198 199

Pas de commentaire

Multitech RF310E Guide de l'utilisateur Page 83