Multitech MTCMR-H Guide de l'utilisateur télécharger pdf (Page 27)

Chapter 2 – Modem-Specific Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 27

+RSCP Return Received Signal Code Power (RSCP)

Note: This command is for WCDMA only.

Syntax: Query: AT!RSCP?

Response: +RSCP:

RSCP: <value1> dBm [<value2> dBm [<value3> dBm]]

Purpose: Return the RSCP values (signed dBm) of up to three cells, from the

strongest to weakest cell.

Description: Return the RSCP of the active set’s three strongest cells.

Parameters: <value> (RSCP of cell in the active set):

Valid range: -120 dB to -20 dB

!SCACT Activate/Deactivate PDP Context for FIFO Interface

Syntax: Execution: AT!SCACT=<state>[,<pid>]

Response: OK

Purpose: Set the state of the identified profile (<pid>). If no <pid> is specified, profile 1

is updated.

Query: AT!SCACT?[<pid>]

Response: !SCACT: <pid>, <state>

[!SCACT: <pid>, <state>

[...] ]

Purpose: Report the status of the identified profile (<pid>). If no <pid> is specified, the

status of all profiles is returned.

Description: Activate or deactivate the specified PDP context for FIFO interface.

Parameters: <state> (PDP context activation state):

0 = Deactivated

1 = Activated

During assignment, any <state> other than 1 or 2 will return an ERROR response.

<pid> (PDP context definition):

Valid range: 1–16

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 146 147

Pas de commentaire

Multitech MTCMR-H Guide de l'utilisateur Page 27