Multitech MTCMR-H Guide de l'utilisateur télécharger pdf (Page 58)

Chapter 3 – Supported GSM/WCDMA AT Commands

High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 58

S3 Set Command Line Termination Character

Description: This command is used to set the command line termination character on an incoming

command line. The value is not persistent.

Syntax: Command syntax: ATS3=<value>

Command Possible Responses

ATS3=13

Note: Set detection character to carriage return

Values: <char> Character decimal representation

1 – 127 Escape character (default is 13 or the carriage return character)

S4 Set Response Formatting Character

Description: This command sets the value of the AT defined character when formatting the result codes

and information text. It is used together with the ATS3 command. The value is not persistent.

Syntax: Command syntax: ATS4=<value>

Command Possible Responses

ATS4=10

Note: Set detection character to line feed

Values: <char> Character decimal representation

1 – 127 Escape character (default is 10 or the carriage return character)

S5 Set Command Line Editing Character

Description: This command sets the value of the defined character for deleting the immediately

preceding character from the command line. The value is not persistent.

Syntax: Command syntax: ATS5=<value>

Command Possible Responses

ATS5=8

Note: Set detection character to backspace

Values: <char> Character decimal representation

1 – 127 Escape character (default is 8 or the carriage return character)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 146 147

Pas de commentaire

Multitech MTCMR-H Guide de l'utilisateur Page 58