Multitech RF102S Guide de l'utilisateur télécharger pdf (Page 49)

Chapter 5 - RouteFinder Manager

Packets defined by User

If you choose to define by User, you must define the byte pattern of the packets. The RF102S

uses the defined byte patterns to block or pass packets from the WAN or from the LAN.

1. In the Block tab, select the Enable Block User Defined Pattern Function check box.

2. In the Packets defined by User area, select From LAN or From WAN.

Starting from which byte number

Enter the first byte in the packet the RF102S should read to determine if the byte pattern (in Hex)

is one that should be filtered. Exclude the PPP header. Start from byte 0 of the network

protocol.

Byte Pattern (in Hex)

Enter the packet byte pattern that you would like the RF102S to recognize as a packet to be

filtered. (Block/Pass from the WAN to the LAN). The maximum pattern size is 12 bytes.

Click Insert to add each byte pattern to the table.

To delete a defined packet, select the packet in the table and click Delete.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 113 114

Pas de commentaire

Multitech RF102S Guide de l'utilisateur Page 49