Multitech MTCBA-G-F2 Manuel d'utilisateur télécharger pdf (Page 15)

Chapter 2 – Dialing Services

Multi-Tech Systems, Inc. AT Commands for Wireless Modems with IP Connectivity (S000333D) 15

Display Parameters

#DISPLAYIP Display IP Addresses

Definition: This command allows the attached host to view the attributed IP addresses that have been attributed

during the IPCP phase of the PPP negotiation. Both local and remote PPP peer IP addresses are

displayed. This command should be issued only once the PPP OK message has been received from

the TCP/IP stack.

Values: Read Parameters:

PPPMYIP

PPPPEERIP

Syntax: AT#DISPLAYIP

Response Syntax: MY IP: xxx.xxx.xxx.xxx

PEER IP: xxx.xxx.xxx.xxx

GSM Mode

Command (GSM Mode) Possible Responses

AT#DISPLAYIP

Note: Request for local and

remote IP addresses

MY IP: 1.2.3.4

PEER IP: 1.0.3.5

Note: PPPMYIP (IP address attributed to the TCP/IP stack) and

PPPPEERIP (IP address attributed to the PPP peer) parameter

values

AT#DISPLAYIP

Note: Request for local and

remote IP addresses

#CME ERROR: 35867

Note: No IP addresses have been attributed: no active

connection or PPP/IPCP negotiation not yet completed

GPRS Mode

Command (GPRS Mode) Possible Responses

AT#DISPLAYIP

Note: Request for local and

remote IP addresses

MY IP: 1.2.3.4

Gateway IP: 1.0.3.5

Note: PPPMYIP (IP address attributed to the TCP/IP stack) and

PPPPEERIP (IP address attributed to the PPP peer) parameter

values

AT#DISPLAYIP

Note: Request for local and

remote IP addresses

#CME ERROR: 35867

Note: No IP addresses have been attributed: no active

connection or PPP/IPCP negotiation not yet completed

#VPPP Display PPP Parameters

Definition: This command directs the TCP/IP stack to display all the AT# parameters related to the PPP layer

configuration.

Values: Read Parameters:

ISPPW

ISPUN

PPPMODE

PPPMYIP

PPPPEERIP

PPPSERVUN

PPPSERVPW

Syntax: AT#VPPP

Command Possible Responses

AT#VPPP #ISPUN: “myispun”

#ISPPW: “myisppwd:

#PPPMODE: 1

#PPPMYIP: “0.0.0.0”

#PPPPEERIP: “0.0.0.0”

#PPPSERVUN: “myname”

#PPPSERVPW: “mypasswd”

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Multitech MTCBA-G-F2 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Multitech MTCBA-G-F2