Multitech MTCBA-G-F2 Manuel d'utilisateur télécharger pdf (Page 26)

Chapter 4 – FTP Services

Multi-Tech Systems, Inc. AT Commands for Wireless Modems with IP Connectivity (S000333D) 26

Chapter 4 – FTP Services

Parameter Definitions

#FTPPORT Enter FTP Server Port

Definition: To reach the FTP server, the TCP/IP stack software must know the control port of the FTP server used

for file transfer.

Note: This parameter should be changed only upon request of your network administrator since it

applies to network infrastructure including firewalls, proxy or specific TCP port translation.

Values: From 1 to 5 digits (each digit between 0 and 9 inclusive).

Note that numbers above 65,535 are illegal as the port identification fields are 16 bits long in the TCP

header. Default 21.

Syntax: Set Value: AT#FTPPORT=<value>

Get Value: AT#FTPPORT? or AT#VFTP, AT#VALL

#FTPMODE Enter FTP Mode

Definition: Define the FTP behavior for file transfer.

Values: 0 FTP Active Mode. Default.

1 FTP Passive Mode

Syntax: Set Value: AT#FTPMODE=<value>

Get Value: AT#FTPMODE? or AT#VFTP, AT#VALL

#FTPTYPE Specify Data Type

Definition: Before transferring files from a specified FTP server, the TCP/IP stack software must specify the type of

data to be transferred within the FTP session.

Values: A FTP ASCII sessions

I FTP Binary sessions (upper case i letter). Default.

Note: When this value is set to A, all the data sent by the TCP/IP stack to the FTP server is made of 7

bits characters (NVT-ASCII: the MSB is set to 0). As a consequence binary data containing 8 bits

characters will be corrupted during the transfer if the FTPTYPE is set to A.

Syntax: Set Value: AT#FTPTYPE=<value>

Get Value: AT#FTPTYPE? or AT#VFTP, AT#VALL

#FTPSERV Specify FTP Server Address

Definition: FTP server address. To connect to an FTP server to download files, the TCP/IP stack software must

know the address of the FTP server that is to be used.

Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or

Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.

Syntax: Set Value: AT#FTPSERV=<value>

Get Value: AT#FTPSERV? or AT#VFTP, AT#VALL

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 77 78

Pas de commentaire

Multitech MTCBA-G-F2 Manuel d'utilisateur Page 26