Multitech MVP100GK Guide de l'utilisateur télécharger pdf (Page 11)

Chapter 2 – Installation

Multi-Tech Systems, Inc. MultiVOIP Gatekeeper User Guide 11

The Command Modem is built into the Gatekeeper unit. To configure the Gatekeeper remotely using its Windows

GUI, you must call into the Gatekeeper’s Command Modem. Once a connection is made, the configuration

process is identical to local configuration with the Windows GUI.

Figure 2-2. GND & Remote Config Modem Connections

5. Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded when

mounted within a rack.

This can be accomplished by connecting a grounding wire between the chassis grounding screw (see

Figure 3-9) and a metallic object that will provide an electrical ground.

6. Turn on power to the Gatekeeper by setting the power switch on the right side panel to the ON position.

Wait for the Boot LED on the Gatekeeper to go off before proceeding. This may take a couple of minutes.

Proceed to Loading Gatekeeper Software section.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 90 91

Pas de commentaire

Multitech MVP100GK Guide de l'utilisateur Page 11