Multitech MTCBA-C-U-N2 Spécifications télécharger pdf (Page 23)

Chapter 2 – Configuration Commands

Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 23

2.8 ATZ Set all Current Parameters to User Defined

Profile

Description: ATZ sets all current parameters to the user profile stored with AT&W. If a connection is in

progress, it will be terminated.

All defined GPRS contexts which are not activated or not online will be undefined if the non-

volatile storage of the CGDCONT settings is not activated by the AT^SCFG parameter

"GPRS/Persistent Contexts" (see AT+CGDCONT). The user defined profile is stored to the non-

volatile memory.

The user defined profile is stored to the non-volatile memory.

Syntax: Exec Command: ATZ[value]

Response: OK

Parameter: <value>:

0 Reset to user profile.

Notes:

• First the profile will be set to factory default (see AT&F). If there is a valid user profile (stored with AT&W),

this profile will be loaded afterwards.

• Any additional commands on the same command line may be ignored. A delay of 300 ms is required before

next command is sent, otherwise “OK” response may be corrupted.

• This command is not PIN protected.

• This command is supported in airplane mode.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 307 308

Pas de commentaire

Multitech MTCBA-C-U-N2 Spécifications Page 23