Multitech MTCBA-C-U-N2 Spécifications télécharger pdf (Page 283)

Chapter 18 – Miscellaneous Commands

Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 283

18.3 ATS4 Set Response Formatting Character

Description: The ATS4 command determines the character generated by the TA for result code and

information text, along with the ATS3 parameter.

Syntax: Read Command ATS4?

Response: <n>

Write Command: ATS4=<n>

Response: OK

ERROR

Parameter:

<n> This parameter can be stored with AT&W and can be displayed with AT&V.

Response formatting character

000....127 Default = 10. This is the factory default value and can be restored to '10' with AT&F.

Notes:

• Whenever you change the setting take into account that the new value has no effect on the URC

“^SHUTDOWN”.

• This command is not PIN protected.

• This command is supported in airplane mode.

18.4 ATS5 Write Command Line Editing Character

Description: This parameter setting determines the character recognized by TA as a request to delete the

immediately preceding character from the command line.

Syntax: Read Command: ATS5?

Response: <n>

Write Command: ATS5=<n>

Response: OK

ERROR

Parameter:

<n> This parameter can be stored with AT&W and can be displayed with AT&V.

Command line editing character

000....127 Default = 8. This is the factory default value and can be restored to '8' with AT&F.

Notes:

• This command is not PIN protected.

• This command is supported in airplane mode.

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 307 308

Pas de commentaire

Multitech MTCBA-C-U-N2 Spécifications Page 283