Multitech MultiConnect Adapter Guide de l'utilisateur télécharger pdf (Page 105)

Chapter 10 – SMTP Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 105

Scenario 2 – Sending a Text Email Using

Interactive Mode

This scenario sends a text email with the message body is entered in interactive mode.

Issue the following command:

send-mail

-t "<email #1>, <email #2>"

-c "<email #3>, <email #4>"

-s "subject data"

The SMTP session then enters into interactive mode and requests that the message body be entered (see the figure

below). After typing the message, type Ctrl+D to end the message.

The email is sent only to the to-addresses (if any) and the cc-addresses (if any) entered from the command prompt.

The subject is taken from the command prompt.

Notes

1. The email is not sent to addresses pre-configured using set commands.

2. At least one address, either the to-address or the cc-address, should be given as an alternative to

sending email directly from the command prompt.

3. If the subject option is not specified and is not pre-configured using set command, SNMP enters into

interactive mode and requests a subject to be entered.

4. Type Ctrl+C to quit the email at any given time.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 153 154

Pas de commentaire

Multitech MultiConnect Adapter Guide de l'utilisateur Page 105