Multitech MultiConnect Adapter Guide de l'utilisateur télécharger pdf (Page 118)

Chapter 11 – POP3 Client

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 118

Scenario 8 – Sending a Mime Encoded Binary

Email with Attachment

Sending a Mime Encoded Binary Email with Attachment Using Interactive Mode

Issue the following command: send-mail -b

The SMTP session then enters into interactive mode requesting the to-address, the cc-address, subject, and

message body to be entered. After completion of the message, type Ctrl+D to end the message.

The SMTP session enters into interactive mode requesting media-type, media-subtype, filename, filesize, and the

attachment body as shown in the figure.

When the attachment body reaches the filesize, another message is displayed asking whether to continue with one

more attachment. Type n for No. The email with its attachment is sent only to the entered to-addresses (if any) and

cc-addresses (if any). The subject and message body are used as entered in the interactive mode.

Notes

• The email is sent only to addresses entered in interactive mode.

• If the subject is pre-configured using set commands, it will be used as the subject for the email.

• Type Ctrl+C to quit the email at any given time.

• If the host wants to quit the email while sending the binary attachment body, type Ctrl+C and wait for 3

seconds without entering any character to quit the email.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 153 154

Pas de commentaire

Multitech MultiConnect Adapter Guide de l'utilisateur Page 118