Multitech MultiConnect Adapter Guide de l'utilisateur télécharger pdf (Page 94)

Chapter 8 – Point-to-Point Protocol

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 94

Wakeup-on Call Feature

This command enables or disables the wakeup-on call feature.

Command: #set ppp <interface> wakeup-on-call <enable/disable>

This command sets the wakeup-on caller-ids

Command: #set ppp <interface> wakeup-callerid <callerid-num> <callerid-str>

Example: #set ppp ppp0 wakeup-callerid 1 „XXX:123“

User can configure 10 caller-ids for caller validation.

The delay in seconds before the “PPP linkup” initiation after receiving a valid caller-id.

Command: #set ppp <interface> wakeup-delay <1-60> secs

This command sets the modem init-strings for wakeup-on call functionality:

Command: #set serial s1 modem wakeup-init-string <init-num> <init-str>

Example: #set serial s1 modem wakeup-init-string 1 “AT+CLIP=1”

Show Commands

This command allows you to view the PPP configuration settings.

Command: #show ppp ppp0 configuration

This command allows you to view the PPP logical link status

Command: # show ppp [interface] link-status

Example: #show ppp ppp0 link-status

Up / Down

This command allows you to view the PPP link IP address

Command: # show ppp [interface] ip-addr

Example: #show ppp ppp0 ip-addr

local: 192.168.2.1

remote: 192.168.2.2

This command allows you to view the PPP traces

Command: # show ppp [interface] trace

Example: #show ppp ppp0 trace

If PPP trace is enabled and PPP deamon is started, then available ppp traces displays.

If PPP trace is disabled or no PPP link is tried after boot, displays the error.

ERROR: PPP traces not available

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 153 154

Pas de commentaire

Multitech MultiConnect Adapter Guide de l'utilisateur Page 94